its end tapered for about three or four threads
its end tapered for about eight or ten threads
full threads for the whole of its length
none of the above
✅ The correct answer is option B.
Production Engineering MCQs
Cemented carbide tools are generally poor in shear.
Yes
No
✅ The correct answer is option A.
Larger than 15° side cutting edge angle
increases tool life
decreases tool life
produces chipping and decreases tool life
results in excessive s
✅ The correct answer is option C.
The abrasive slurry used in ultra-sonic machining contains fine particles of
aluminium oxide
boron carbide
silicon carbide
any one of these
✅ The correct answer is option D.
The high cutting speed and large rake angle of the tool will result in the formation of
continuous chips
discontinuous chip
continuous chips with built up edge
none of these
✅ The correct answer is option A.
The cutting force in up milling __________ per tooth movement of the cutter.
is zero
is maximum
decreases from maximum to zero
increases from zero to
✅ The correct answer is option D.
The operation performed on a shaper is
machining horizontal surface
machining vertical surface
machining angular surface
all of these
✅ The correct answer is option D.
A single point tool has
rake angle
cutting angle
lip angle
all of these
✅ The correct answer is option D.
In machining cast iron, no cutting fluid is required.
Correct
Incorrect
✅ The correct answer is option A.
Tool life is measured by the
number of pieces machined between tool sharpenings
time the tool is in contact with the job
volume of material removed between tool sharpenings
all of the above
✅ The correct answer is option D.