A. displacement
B. load
C. slope
D. moment
✅ The correct answer is option A.
Civil Engineering
Prepare with the latest Civil Engineering MCQs with answers and explanations for exams, interviews, and job tests. Our question bank covers key topics including surveying, building materials, structural engineering, geotechnical engineering, fluid mechanics, hydraulics, transportation engineering, environmental engineering, and construction management. These Civil Engineering multiple-choice questions are designed for students, competitive exam aspirants, and professionals preparing for NTS, PPSC, FPSC, PEC exams, university entry tests, and recruitment assessments. Strengthen your knowledge and problem-solving skills with our updated and comprehensive Civil Engineering MCQs.
1092. If the 20 mm rivets are used in lacing bars, then the minimum width of lacing bar should be______________?
A. 40mm
B. 60mm
C. 80mm
D. 100mm
✅ The correct answer is option B.
1093. The bracing provided in the plane of end posts is called__________________?
A. sway bracing
B. portal bracing
C. top lateral bracing
D. bottom lateral bracing
✅ The correct answer is option B.
1094. In case of timber structures, the simple bending formula M = fz may be applied for________________?
A. rectangular beams up to 300 mm depth
B. all rectangular beams
C. solid circular beams only
D. all square cross-section beams
✅ The correct answer is option A.
1095. To minimize the total cost of a roof truss, the ratio of the cost of truss to the cost of purlins shall be_______________?
A. 1
B. 2
C. 3
D. 4
✅ The correct answer is option B.
1096. Hudson’s formula gives the dead weight of a truss bridge as a function of_________________?
A. bottom chord area
B. top chord area
C. effective span of bridge
D. heaviest axle load of engine
✅ The correct answer is option A.
1097. Normally, the angle of roof truss with asbestos sheets should not be less than_______________?
A. 26’/2°
B. 30°
C. 35°
D. 40°
✅ The correct answer is option B.
1098. The maximum slenderness ratio of a compression member carrying both dead and superimposed load is___________________?
A. 180
B. 200
C. 250
D. 350
✅ The correct answer is option A.
1099. According to IS Specifications, the effective length of a column effectively held in position at both ends and restrained in direction at one end is taken as________________?
A. 0.67 L
B. 0.8 L
C. L
D. 1.5 L
✅ The correct answer is option B.
1100. The range of economical spacing of trusses varies from________________?
A. L/3 to L/5
B. L/4to2L/5
C. L/3 to L/2
D. 2L/5 to 3L/5 where L is span
✅ The correct answer is option A.