The workpiece is supported throughout its entire length as grinding takes place.
It is a continuous process and adopted for production work.
It requires no holding device for the work.
all of the above
✅ The correct answer is option D.
Production Engineering MCQs
A right hand tool on a lathe cuts most efficiently when it travels
from left to right end of the lathe bed
from right to left end of the lathe bed
with the help of a compound slide
across the bed
✅ The correct answer is option B.
In a universal milling machine, the table can be swiveled horizontally and can be fed at an angle to the milling machine spindle.
TRUE
FALSE
✅ The correct answer is option A.
In centreless grinders, the regulating wheel is inclined at
0° to 8°
9° to 15°
16° to 20°
21° to 25°
✅ The correct answer is option A.
If the grain size is __________ the tool life is better.
smaller
larger
✅ The correct answer is option B.
Which of the following statement is correct for orthogonal cutting system?
The cutting edge of the tool is perpendicular to the direction of tool travel.
The cutting edge clears the width of the workpiece on either ends.
The chip flows over the tool face and the direction of the chip flow velocity is normal to the cutting edge.
all of the above
✅ The correct answer is option D.
Flank wear depends upon the
hardness of the work and tool material at the operating temperature
amount and distribution of hard constituents in the work material
degree of strain hardening in the chip
all of these
✅ The correct answer is option B.
Side relief angle of a single point tool is the angle
by which the face of the tool is inclined towards back
by which the face of the tool is inclined sideways
between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of tool
between the surface of
✅ The correct answer is option C.
Flank wear is due to the abrasive action of hard mis-constituents including debris from built up edge as the work material rubs the work surface.
Correct
Incorrect
✅ The correct answer is option A.
A grinding wheel is said to be of __________ if the abrasive grains can be easily dislodged.
soft grade
medium grade
hard grade
✅ The correct answer is option A.