by a form tool
by setting over the tail stock
by a taper turning attachment
by swivelling the comp
✅ The correct answer is option C.
Production Engineering MCQs
Crater wear is predominant in
carbon tool steels
tungsten carbide tools
high speed steel tools
ceramic tools
✅ The correct answer is option B.
In drilling operation, the metal is removed by
shearing
extrusion
shearing and extrusion
shearing and compressi
✅ The correct answer is option C.
Trepanning is an operation of
making a cone-shaped enlargement of the end of a hole
smoothing and squaring the surface around a hole
sizing and finishing a small diameter hole
producing a hole by re
✅ The correct answer is option D.
The hole to be drilled for tapping is __________ the outside diameter of the thread on the tap.
equal to
smaller than
greater than
✅ The correct answer is option B.
In centreless grinding, work place centre will be
above the line joining the two wheel centres
below the line joining the two wheel centres
on the line joining the two wheel centres
at the intersection of
✅ The correct answer is option A.
Hard and tough materials like cast iron should be turned at
slow speed
high speed
any speed
certain specific speed
✅ The correct answer is option A.
The point angle of a drill, for drilling stainless steel, is
90°
118°
135°
150°
✅ The correct answer is option C.
Carbide tipped tools usually have
negative rake angle
positive rake angle
any rake angle
no rake angle
✅ The correct answer is option A.
The grooving is an operation of
bevelling the extreme end of a workpiece
embossing a diamond shaped pattern on the surface of a workpiece
reducing the diameter of a workpiece over a very narrow surface
enlarging the end of a
✅ The correct answer is option C.