infeed grinding
through feed grinding
endfeed grinding
any one of these
✅ The correct answer is option C.
Mechanical Engineering MCQs
Gears are casted by
sand mould casting
slush casting
permanent mould casting
centrifugal casting
✅ The correct answer is option C.
The unit of surface tension is
N/m
N/m2
N/m3
N-m
✅ The correct answer is option A.
The size of a shaper is given by
stroke length
motor power
mass of machine
rate size
✅ The correct answer is option A.
In case of sensible heating of air, the coil efficiency is given by (where B.P.F. = By-pass factor)
B.P.F. – 1
1 – B.P.F.
1 + B.RF.
✅ The correct answer is option B.
In metal cutting operations, the shear angle is the angle made by the shear plane with the
direction of the tool axis
direction of tool travel
perpendicular to the direction of the tool axis
central plane of the w
✅ The correct answer is option B.
In the two rotor system as shown in the below figure (I1 < I2), a node of vibration is situated
between I1, and I2 but nearer I1
between I1, and I2 but nearer to I2
exactly in the middle of the shaft
nearer to I1 but outsi
✅ The correct answer is option B.
In a petrol engine, the high voltage for spark plug is in the order of
1000 volts
2000 volts
11 kilovolts
22 kilovolts
✅ The correct answer is option D.
In steady state forced vibrations, the amplitude of vibrations at resonance is __________ damping coefficient.
equal to
directly proportional to
inversely proportional to
independent of
✅ The correct answer is option C.
The pressure angle of a cam is the angle between the direction of the follower motion and a normal to the pitch curve.
Correct
Incorrect
✅ The correct answer is option A.