The air-fuel ratio of the petrol engine is controlled by September 8, 2025 by Admin carburettor injector governor none of these ✅ The correct answer is option A.
Equal volumes of all gases, at the same temperature and pressure, contain equal number of molecules. This statement is called Avogadro’s law. September 8, 2025 by Admin TRUE FALSE ✅ The correct answer is option A.
The operation of cutting a number of holes evenly spaced in a regular pattern on a sheet of metal is. called perforating. September 8, 2025 by Admin Agree Disagree ✅ The correct answer is option A.
Conduction is the process of heat transfer from one particle of the body to another by the actual motion of the heated particles. September 8, 2025 by Admin TRUE FALSE ✅ The correct answer is option B.
The temperature of air at the beginning of the compression stroke is __________ the atmospheric temperature. September 8, 2025 by Admin equal to less than more than ✅ The correct answer is option C.
A framed structure, as shown in the below figure, is a September 8, 2025 by Admin perfect frame deficient frame redundant frame none of the above ✅ The correct answer is option A.
Oil separator in a refrigeration cycle is installed September 8, 2025 by Admin before compressor between compressor and condenser between condenser and evaporator between condenser and ✅ The correct answer is option B.
When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl’s stress factor, and W = Axial compressive load on the spring) September 8, 2025 by Admin ✅ The correct answer is option D.
In a receiver type compound engine, the high pressure and low pressure cylinders September 8, 2025 by Admin have common piston rod are set at 90° have separate piston rods are set in V – arrange ✅ The correct answer is option C.
The operation of cutting a sheet of metal in a straight line along the length, is known as September 8, 2025 by Admin plunging notching slitting forming ✅ The correct answer is option C.