For absorbers, high pressure drop results in September 7, 2025 by Admin Increased efficiency Decreased efficiency High operating cost Better gas liquid contact ✅ The correct answer is option C.
In case of a desorber (stripper), the September 7, 2025 by Admin Operating line always lies above the equilibrium curve Operating line always lies below the equilibrium curve Temperature remains unaffected Temperature always increases ✅ The correct answer is option B.
Flash distillation is suitable for the separation of components September 7, 2025 by Admin Having very close boiling points Which form maximum boiling azeotrope Having very wide boiling points Which form minimum boiling azeotrope ✅ The correct answer is option C.
Diameter of raschig rings used in packed tower in industry is normally around __________ inches. September 7, 2025 by Admin 2 8 12 18 ✅ The correct answer is option A.
Milk is dried usually in a __________ dryer. September 7, 2025 by Admin Freeze Spray Tray Rotary ✅ The correct answer is option B.
Make up water is required in a cooling tower to replace the water lost by September 7, 2025 by Admin Evaporation Drift Blowdown and leakage All of the above ✅ The correct answer is option D.
Fenske equation determines the September 7, 2025 by Admin Maximum number of ideal plates Height of the distillation column Minimum number of theoretical plates Optimum reflux ratio ✅ The correct answer is option C.
__________ extractor is used for the concentration of radioactive nuclear waste. September 7, 2025 by Admin Pulsed column Seive plate Mixer-settler Ballman ✅ The correct answer is option A.
The interfacial area per unit volume of dispersion, in a gas-liquid contactor, for fractional hold up of gas = 0.1 and gas bubble diameter = 0.5 mm is given by (in m²/m³) September 7, 2025 by Admin 500 1200 900 800 ✅ The correct answer is option A.
In case of binary distillation, increasing the reflux ratio above optimum does not result in the increase of September 7, 2025 by Admin Area between operating line and 45° diagonal x-y diagram Condenser and reboiler surfaces Tower cross-section None of these ✅ The correct answer is option A.