A. Steam temperature & pressure
B. Steam output (tons/hr)
C. Heat transfer rate (kcal/hr)
D. Heat transfer area (m²)
✅ The correct answer is option B.
Engineering MCQs
Which of the following is the most suitable for removing fine particles (< 1 micron diameter) from air below its dew point?
A. Venturi scrubber
B. Electrostatic precipitator
C. Cyclone separator
D. Fabric filter
✅ The correct answer is option B.
Load cells used for the measurement of weight has
A. Compact & rugged construction with an accuracy of 0.1 to 1%
B. No moving parts and incurs negligible deflection under load
C. Provision of thermal compensation and is hermetically sealed
D. All of the above
✅ The correct answer is option D.
Parallel straight line pattern of temperature distribution for both hot and cold fluids is observed in case of heat exchanger of the type
A. Parallel flow with equal heat capacities
B. Counter flow with equal heat capacities
C. Counter flow with unequal heat capacities
D. Parallel flow with unequal heat capacities
✅ The correct answer is option B.
Blast furnace is a
A. Counter current reactor
B. Co-current reactor
C. Cross-current reactor
D. Combination of all the three
✅ The correct answer is option A.
In chemical dehumidification of air
A. Both specific humidity & dry bulb temperature increases
B. Both specific humidity & dry bulb temperature decreases
C. Specific humidity decreases & dry bulb temperature increases
D. Specific humidity increases & dry bulb temperature decreases
✅ The correct answer is option C.
A good abrasive
A. Should be friable
B. Should have low refractoriness
C. Is made up of large size of crystals
D. Should be soft
✅ The correct answer is option A.
Young’s modulus of elasticity of a material is the slope of the initial linear portion of the stress-strain curve. It decreases ap-preciablyby
A. Alloying additions
B. Heat treatment
C. Cold work
D. Increasing temperature
✅ The correct answer is option B.
A 2 kg object weighs 1.8 kgf on a spring balance. The value of ‘g’ at that location in m/seC₂ is
A. 8.82
B. 9.81
C. 10.88
D. 0.95
✅ The correct answer is option A.
Area under the stress-strain curve upto the __________ is referred to as the modulus of resilience.
A. Yield strength
B. Elastic limit
C. Proportional limit
D. Maximum point
✅ The correct answer is option C.