flat type
V-type
dovetail type
any one of these
✅ The correct answer is option D.
Engineering MCQs
Flank wear occurs mainly on the
nose part, front relief face and side relief face of the cutting tool
face of the cutting tool at a short distance from the cutting edge
cutting edge only
front face only
✅ The correct answer is option A.
The extremeties of any diameter on Mohr’s circle represent
principal stresses
normal stresses on planes at 45°
shear stresses on planes at 45°
normal and shear stres
✅ The correct answer is option B.
The capacity of a battery is usually expressed in terms of
volts
amperes
weight
ampere-hours
✅ The correct answer is option D.
The difference between the upper limit and lower limit of a dimension is called
nominal size
basic size
actual size
tolerance
✅ The correct answer is option D.
A column of length l is fixed at both ends. The equivalent length of the column is
l/2
l/2
l
2 l
✅ The correct answer is option A.
The maximum fluctuation of energy is the
difference between the maximum and minimum energies
sum of the maximum and minimum energies
variations of energy above and below the mean resisting torque line
ratio of the mean resi
✅ The correct answer is option A.
The pressure of liquid at throat in a venturimeter is __________ than that at inlet.
higher
lower
✅ The correct answer is option B.
Two general types of tyres are
tube type and tubeless
solid and tubeless
air and pneumatic
split-rim and drop cen
✅ The correct answer is option A.
The unit of power in S.I. units is kilowatt.
TRUE
FALSE
✅ The correct answer is option A.