Low helix angle drills are preferred for drilling holes in September 13, 2025 by Admin plastics copper cast steel carbon steel ✅ The correct answer is option A.
A beam encastered at both the ends is called September 13, 2025 by Admin simply supported beam fixed beam cantilever beam continuous beam ✅ The correct answer is option B.
The draught (in mm of water), for maximum discharge of flue gases through the chimney, is given by (where H = Height ot the chimney in metres, and T1 = Absolute temperature of air outside the chimney in K) September 13, 2025 by Admin ✅ The correct answer is option D.
The addition of magnesium to cast iron increases its September 13, 2025 by Admin hardness ductility and strength in tension corrosion resistance creep strength ✅ The correct answer is option B.
Brittle materials when subjected to tensile loads, snap off without giving any sensible elongation. September 13, 2025 by Admin Yes No ✅ The correct answer is option A.
Moment of inertia of a triangular section of base (b) and height (h) about an axis passing through its vertex and parallel to the base, is __________ than that passing through its C.G. and parallel to the base. September 13, 2025 by Admin nine times six times four times two times ✅ The correct answer is option A.
Pearlite is a combination of 87% ferrite and 13% cementite. September 13, 2025 by Admin Yes No ✅ The correct answer is option A.
The temperature required for full annealing in hyper-eutectoid steel is September 13, 2025 by Admin 30° C to 50° C above upper critical temperature 30° C to 50° C below upper critical temperature 30° C to 50° C above lower critical temperature 30° C to 50° C below l ✅ The correct answer is option C.
Vanadium when added to steel September 13, 2025 by Admin increases tensile strength decreases tensile strength raises critical temperature Sowers critical temper ✅ The correct answer is option A.
The Rankine’s constant for a mild steel column with both ends hinged is September 13, 2025 by Admin 1/750 1/1600 Jan-00 Jan-00 ✅ The correct answer is option C.