With increase in C/H ratio of a fuel, the dew point of flue gases September 7, 2025 by Admin Increases Decreases Remains same May increase or decrease ; depends on the type of fuel ✅ The correct answer is option B.
Yield of coke oven gas in low temperature carbonisation of coal is about __________ Nm³ /ton of dry coal. September 7, 2025 by Admin 60 160 500 750 ✅ The correct answer is option B.
When incomplete combustion loss is high, the flue gas analysis shows large amount of September 7, 2025 by Admin CO₂ CO O₂ C ✅ The correct answer is option B.
Which of the following is the most important deterrents to an extended use of pulverised coal in boiler firing? September 7, 2025 by Admin Ash disposal problem Excessive fly-ash discharge from the stack High power consumption in its transportation Erosion of induced draft fan blades ✅ The correct answer is option A.
Turndown ratio of a gas burner is equal to the September 7, 2025 by Admin Maximum to minimum heat input ratio Maximum to minimum permissible gas flow rate Both A & B Minimum to maximum heat input ratio ✅ The correct answer is option C.
Theoretical flame temperature of a fuel is that temperature which is attained, when the fuel is completely burnt ‘using theoretical amount of air in September 7, 2025 by Admin Air Oxygen Either A or B Either A or C without gain or loss of heat ✅ The correct answer is option D.
Silica bricks are attacked by basic slags at high temperature. Which of the following is not used solely as a binding material? September 7, 2025 by Admin aluminium phosphate water lime plaster of paris ✅ The correct answer is option B.
Rotary kilns meant for calcination of limestone are lined with chrome magnesite in __________ zone. September 7, 2025 by Admin preheating cooling burning all ✅ The correct answer is option C.
Dolomite bricks have good resistance to attack by September 7, 2025 by Admin molten steel iron oxide lime slag none of these ✅ The correct answer is option A.
Beryllia (which is used in making crucibles for melting uranium & thorium) is superior to alumina in all respects for high temperature (> 1900°C ) use, except September 7, 2025 by Admin cost electrical conductivity thermal conductivity fusion point ✅ The correct answer is option A.