131. For static balancing of a shaft, the net dynamic force acting on the shaft is equal to zero. Agree Disagree ✅ The correct answer is option A.
132. The natural frequency of free transverse vibrations due to a point load acting over a simply supported shaft is equal to (where δ = Static deflection of a simply supported shaft due to the point load) ✅ The correct answer is option A.
133. The coriolis component of acceleration acts along the sliding surface perpendicular to the sliding surface at 45° to the sliding surface parallel to the slidin ✅ The correct answer is option B.
134. The coefficient of fluctuation of energy is the ratio of maximum energy to the minimum energy. TRUE FALSE ✅ The correct answer is option B.
135. A shaft of mass (mc)and stiffness (s) is fixed at one end and carries a mass (m) at the other end. The natural frequency of its transverse vibration is same as for longitudinal vibration. Yes No ✅ The correct answer is option B.
136. When a mass of a critically damped single degree of freedom system is deflected from its equilibrium position and released, then it will return to equilibriumposition without oscillation oscillate with increasing time period oscillate with decreasing amplitude oscillate with constan ✅ The correct answer is option B.
137. The motion between a pair when limited to a definite direction, irrespective of the direction of force applied, is known as completely constrained motion incompletely constrained motion successfully constrained motion none of these ✅ The correct answer is option A.
138. The minimum force required to slide a body of weight W on a rough horizontal plane is W sin θ W cos θ W tan θ W cosec θ ✅ The correct answer is option A.
139. The frictional torque transmitted in a truncated conical pivot bearing, considering uniform pressure, is μ W cosec α (r1 + r2) μ W cosec α (r1 + r2) μ W cosec α μ W cosec α ✅ The correct answer is option D.
140. An involute pinion and gear are in mesh. If both have the same size of addendum, then there will be an interference between the tip of the gear tooth and flank of pinion tip of the pinion and flank of gear flanks of both gear and pinion tip of both gear and p ✅ The correct answer is option A.